Britax Poplar

When it comes to rear-facing convertible car seats, space can be a major concern. Whether you have a tall front seat occupant, a small backseat, or both, the Britax Poplar’s 6-position recline options can offer a space-saving profile for older kids! Like all rear-facing seats, the Poplar’s front-to-back footprint depends on the recline setting chosen by the adult installing the car seat. When this seat is installed on the most upright rear-facing recline setting, it is one of the most compact rear-facing convertibles on the market!

One of the best specs of this seat is that it is only 17 inches wide. It’s a good option to consider if you need to fit three people or car seats in one row. The ClickTight panel makes it easy to get a snug installation as well, which is really helpful in a tight three-cross situation. Check out all our recommended seats for three-cross situations here.

When it comes to easy, straightforward, wrestle-free car seat installation, ClickTight is about as good as it gets! Britax’s innovative ClickTight technology both tightens and locks the vehicle seatbelt for you. All you have to do is thread the vehicle seatbelt through the correct belt path, buckle it in, gently remove any obvious slack, and close the ClickTight panel. For caregivers who struggle to tighten seatbelts or lower anchor (also referred to as latch) straps when installing other car seats, the Britax Poplar might just be the answer to your car seat woes.

When installing the Britax Poplar car seat, note that the ClickTight panel is designed to be used with the vehicle seatbelt. Don’t even bother with a lower anchor installation; a seatbelt is the way to go for this seat!

This seat has a seat belt lock-off. So it can be a good option in vehicles older than 1996 that don’t have locking seat belts or need to be installed in international vehicles.

If your vehicle has non-removable headrests, we do not recommend that you buy this seat. It is unlikely to be compatible. You can check this post for car seat options that do work with non-removable headrests.

Since this is a new seat, we haven’t had a chance to see any newborns in it yet. Therefore, we can not say for certain whether it does or does not fit newborns well. For more information on this topic, head here.

The harness pads on this seat have some complicated rules. They cannot be removed from the seat at all as they are permanently attached. There is a way to store them, though. For rear-facing children between 22-40 pounds, the harness pads must be attached to the harness. They must be used for the entire forward-facing mode unless you are installing with a lap-only belt. Since most vehicles do not have lap-only belts, this exception would not apply to most people. But if it pertains to you, check the car seat manual for further instructions.

The lower infant insert that goes under the child’s bottom must be used until the child is 22 pounds, at which point it must be removed.

The top tether should always be used when a child is forward-facing. Britax’s top tethers are v-shaped instead of the typical top tether design. Generally this kind of top tether will go around both sides of the vehicle’s headrest.